bdev:rearm_marlin
Warning: Undefined array key -1 in /var/www/html/dokuwiki/inc/html.php on line 1458
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
bdev:rearm_marlin [2021/10/16 14:33] richard |
bdev:rearm_marlin [2021/10/27 23:08] (current) richard |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Re-ARM Marlin ====== | ====== Re-ARM Marlin ====== | ||
| + | \\ | ||
| + | My latest back up | ||
| + | {{ : | ||
| + | \\ | ||
| + | |||
| \\ | \\ | ||
| https:// | https:// | ||
| Line 10: | Line 15: | ||
| Set steps per mm\\ | Set steps per mm\\ | ||
| https:// | https:// | ||
| + | \\ | ||
| \\ | \\ | ||
| Cold extrusion\\ | Cold extrusion\\ | ||
| Line 121: | Line 127: | ||
| {% endif %} | {% endif %} | ||
| </ | </ | ||
| - | |||
| - | |||
| + | \\ | ||
| + | Notes on baby stepping https:// | ||
| + | \\ | ||
| + | https:// | ||
| \\ | \\ | ||
| Zprobe set up \\ | Zprobe set up \\ | ||
| Line 131: | Line 139: | ||
| #define Z_SERVO_ANGLES { 100, 0 } // Z Servo Deploy and Stow angles | #define Z_SERVO_ANGLES { 100, 0 } // Z Servo Deploy and Stow angles | ||
| </ | </ | ||
| + | \\ | ||
| + | Offsets for Z probe\\ | ||
| + | https:// | ||
| \\ | \\ | ||
| Zprobe bilinear\\ | Zprobe bilinear\\ | ||
bdev/rearm_marlin.1634394787.txt.gz ยท Last modified: 2021/10/16 14:33 by richard
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
