Warning: Undefined array key -1 in /var/www/html/dokuwiki/inc/html.php on line 1458

Differences

This shows you the differences between two versions of the page.

--- bdev:rrf_duet3d [2022/08/16 19:11]
richard
+++ bdev:rrf_duet3d [2022/09/15 03:42] (current)
richard
@@ Line 1: / Line 1: @@
 ====== Duet3D labbot files ======
@@ Line 4: / Line 5: @@
-{{:bdev:screen_shot_2022-08-15_at_6.17.05_pm.png?400|}}
+{{:bdev:screen_shot_2022-09-14_at_8.38.28_pm.png?600|}}
+{{:bdev:screen_shot_2022-09-14_at_8.41.18_pm.png?600|}}
@@ Line 36: / Line 40: @@
 | DuetWebControl-SD.zip |
+https://docs.duet3d.com/User_manual/Reference/Gcodes#m280-set-servo-position
 <code>
@@ Line 79: / Line 86: @@
 ^M
 ; Z-Probe^M
-M950 S0 C"exp.heater7"                         ; create servo pin 0 for BLTouch^M
+M950 S0 C"exp.heater7"                         ; create servo pin 0 for BLTouch^M exp.heater7 is pin 31
 M558 P9 C"^zprobe.in" H5 F120 T6000            ; set Z probe type to bltouch and the dive height + speeds^M
 G31 P500 X0 Y0 Z2.5                            ; set Z probe trigger value, offset and trigger height^M
@@ Line 110: / Line 117: @@
 </code>
+To set up camera I did this ... https://elinux.org/RPi-Cam-Web-Interface#Installation_Instructions
+{{:bdev:screen_shot_2022-09-14_at_3.20.31_pm.png?600|}}
+{{:bdev:screen_shot_2022-09-14_at_3.27.25_pm.png?600|}}
+{{:bdev:screen_shot_2022-09-14_at_3.28.51_pm.png?600|}}
+{{:bdev:screen_shot_2022-09-14_at_3.29.57_pm.png?600|}}
+{{:bdev:screen_shot_2022-09-14_at_3.31.59_pm.png?600|}}
+{{:bdev:screen_shot_2022-09-14_at_3.33.45_pm.png?600|}}
+{{:bdev:screen_shot_2022-09-14_at_3.34.56_pm.png?600|}}
+{{:bdev:screen_shot_2022-09-14_at_3.36.37_pm.png?600|}}

labautobox

User Tools

Site Tools

Differences

Page Tools