Differences

This shows you the differences between two versions of the page.

--- bdev:x_and_z_drive_systems [2020/09/26 14:53]
richard
+++ bdev:x_and_z_drive_systems [2021/09/08 16:00] (current)
richard
@@ Line 1: / Line 1: @@
-====== X and Z drive systems ======
+====== X drive systems ======
 After setting up the Y rails now its time to set up X drive. The first step is to get attach an extrusion to the 2 Y sliders:
@@ Line 13: / Line 13: @@
 |{{ :bdev:image-20200510-175947.png?200 |}}|iverntech_slider_tslot \\ {{ :bdev:iverntech_slider_tslot_connector_1_.stl |}}|
 |{{ :bdev:image-20191222-165449.png?200 |}}|iverntech_slider_xshuttle_connect \\ {{ :bdev:iverntech_slider_xshuttle_connect.stl |}}|
+|{{ :bdev:image-20191222-170341.png?200 |}}|slider_front_assy_multichannel_iverntech \\ {{ :bdev:slider_front_assy_multichannel_iverntech.stl |}}|
+|{{ :bdev:image-20191222-170547.png?200 |}}|shuttle_back \\ {{ :bdev:shuttle_back.stl |}}|
+|{{ :bdev:image-20191222-171950.png?200 |}}|beltclamp \\ {{ :bdev:beltclamp.stl |}}|
+|{{ :bdev:image-20200516-011300.png?200 |}}|motormount_centered \\ {{ :bdev:motormount_centered.stl |}}|
+|{{:bdev:endstop_x.png?200|}}|endstop_x \\ {{:bdev:endstop_x.stl |}}|

labautobox