Differences

This shows you the differences between two versions of the page.

--- bdev:x_and_z_drive_systems [2020/09/26 15:24]
richard
+++ bdev:x_and_z_drive_systems [2021/09/08 16:00] (current)
richard
@@ Line 1: / Line 1: @@
-====== X and Z drive systems ======
+====== X drive systems ======
 After setting up the Y rails now its time to set up X drive. The first step is to get attach an extrusion to the 2 Y sliders:
@@ Line 18: / Line 18: @@
 |{{ :bdev:image-20191222-171950.png?200 |}}|beltclamp \\ {{ :bdev:beltclamp.stl |}}|
 |{{ :bdev:image-20200516-011300.png?200 |}}|motormount_centered \\ {{ :bdev:motormount_centered.stl |}}|
+|{{:bdev:endstop_x.png?200|}}|endstop_x \\ {{:bdev:endstop_x.stl |}}|
-|{{ :bdev:image-20191013-223624.png?200 |}}|{{ :bdev:image-20191013-223739.png?200 |}}|
-|{{ :bdev:image-20200516-025929.png?200 |}}|slider_wall_holes // {{ :bdev:slider_wall_holes.stl |}}|

labautobox