bdev:z_drive_systems_bed
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
bdev:z_drive_systems_bed [2021/07/20 20:33] richard |
bdev:z_drive_systems_bed [2021/08/19 15:08] (current) richard |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| It is based on this function, zbed_assy_wider_threadedrod_noextrusion_higher, | It is based on this function, zbed_assy_wider_threadedrod_noextrusion_higher, | ||
| - | | bearing_mount_smz (need 2) |{{: | + | | 300mm x 400mm bed | | | |
| - | | motormount_smz (need 2) | {{: | + | | 2 threaded rods 582mm| | | |
| - | | clamp_bottom_simple_m8_smoothrodholder_for_z (need 4) | {{: | + | | 4 smooth rods 436mm| | | |
| + | | 2 nema17 with 375mm shaft| | | | ||
| + | | bearing_mount_smz (need 2) |{{: | ||
| + | | motormount_smz (need 2) | {{: | ||
| + | | clamp_bottom_simple_m8_smoothrodholder_for_z (need 8) | {{: | ||
| | 4 smooth rods m8 437 mm long | 2 2020 extrusions 437mm long | | | 4 smooth rods m8 437 mm long | 2 2020 extrusions 437mm long | | ||
| | 2 nema 17 with rod 377mm long| {{: | | 2 nema 17 with rod 377mm long| {{: | ||
| + | |T8 nut anti-backlash (need 2) | {{: | ||
| + | | bed_attach_assy_tslot (4 of them) | {{: | ||
| + | |bed_bar_clamp (4 of them) | {{: | ||
| + | |extrusion_threadrod_clamp_noextrusion (4 of them) | {{: | ||
| + | | lm8uu_smz_glider_wider (4 of them) | {{: | ||
| + | | zbedslot_516_smz_zbed_wider (2 of them) | {{: | ||
| + | | endstop support | {{: | ||
bdev/z_drive_systems_bed.1626813223.txt.gz · Last modified: 2021/08/16 22:21 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
