mechanical_overview
Warning: Trying to access array offset on value of type bool in /var/www/html/dokuwiki/inc/html.php on line 1164
Warning: Trying to access array offset on value of type bool in /var/www/html/dokuwiki/inc/html.php on line 1168
Warning: Trying to access array offset on value of type bool in /var/www/html/dokuwiki/inc/html.php on line 1171
Warning: Trying to access array offset on value of type bool in /var/www/html/dokuwiki/inc/html.php on line 1172
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
mechanical_overview [2020/09/24 17:52] richard |
mechanical_overview [2021/08/16 22:22] (current) |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| - Aluminum extrusion frame for supporting the microfluidics devices | - Aluminum extrusion frame for supporting the microfluidics devices | ||
| - ATX power supply unit (PSU) normally used with desktop computers | - ATX power supply unit (PSU) normally used with desktop computers | ||
| - | - Tubing | + | - Tubing 1/8 inch and 1/16 inch diameters for connecting the LabAutoBox to robotics for doing 8 channel pipette liquid handling |
| < | < | ||
| {{: | {{: | ||
| {{: labautobox_mechanical_side_view.png? | {{: labautobox_mechanical_side_view.png? | ||
| - | < | + | < |
| </ | </ | ||
| + | |||
| // | // | ||
| // | // | ||
| - | {{: | + | |
| + | ===== Electronic box plug reference ===== | ||
| + | |||
| + | < | ||
| + | {{: labautobox_mechanical_plugs.png? | ||
| + | < | ||
| + | </ | ||
| + | |||
| + | // | ||
| + | // | ||
| + | |||
| + | |||
| + | The electronic box is used for controlling XYZ gantrys (like 3D printers, old laboratory automation systems, labbots). The attached Raspberry Pi runs the LabAutoBox browser based software and on the front of this electronic box are connections for hooking the different devices for doing liquid handling based laboratory automation. | ||
| + | |||
| + | * X - X motor and endstop | ||
| + | * Y - Y motor and endstop | ||
| + | * Z - Z motor and endstop | ||
| + | * S - Multichannel syringe pump motor and endstop | ||
| + | * H1 - Heater controller unit 1 | ||
| + | * H2 - Heater controller unit 2 | ||
| + | * P - Pressure compensation vessel electrocaloric liquid level sensor | ||
| + | * L - Liquid pumps (wash, waste and PCV) | ||
| + | * H3 - Heater controller unit 3 | ||
mechanical_overview.1600969967.txt.gz · Last modified: 2021/08/16 22:21 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
