Warning: Trying to access array offset on value of type bool in /var/www/html/dokuwiki/inc/html.php on line 1164

Warning: Trying to access array offset on value of type bool in /var/www/html/dokuwiki/inc/html.php on line 1168

Warning: Trying to access array offset on value of type bool in /var/www/html/dokuwiki/inc/html.php on line 1171

Warning: Trying to access array offset on value of type bool in /var/www/html/dokuwiki/inc/html.php on line 1172

Warning: Undefined array key 6 in /var/www/html/dokuwiki/inc/html.php on line 1453

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

--- pressure_compensation_vessel [2020/09/24 23:11]
richard created
+++ pressure_compensation_vessel [2021/08/16 22:22] (current)
@@ Line 5: / Line 5: @@
 The PCV bottle with closed lid shows the gauged wire support the other end of which is attached to the heatable probe, this can be moved up and down to improve the liquid level accuracy
-The pressure compensation vessel settings are done in the Interactive Mode interface. Details about the controls are shown.
+The pressure compensation vessel settings are done in the [[software_overview|Interactive Mode]] interface. Details about the controls are shown.
+<figure>
+{{ ::labautobox_pressurecompensation_position.png?700|Liquid level should be around that of the pipette tips}}
+<caption>**Liquid level should be around that of the pipette tips**</caption>
+</figure>
+----
+<figure>
+{{ ::labautobox_pressurecompensation_position_closebottle.png?500|The electrocaloric liquid level sensor is shown inside the bottle and the LabAutoBox software allows you to set the feedback temperature threshold and the heater power}}<caption>**The electrocaloric liquid level sensor is shown inside the bottle and the LabAutoBox software allows you to set the feedback temperature threshold and the heater power**</caption></figure>
+----

labautobox

User Tools

Site Tools

Differences

Page Tools