labautobox

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Y drive system  ======

The Y rail involves positioning the Iverntech rail system on either side of the scaffold. This OpenSCAD module that lays out these parts are in, xshuttle_assy_wider(). For this set up the Iverntech MGN12 450mm Linear Rail Guide with MGN12H Carriage Block for 3D Printer and CNC Machine which you get from Amazon is used. It positioned in place using these 3D printed connectors. 

|{{ ::iverntech_connector.stl | Rail connector }}|There are 3 on either side. It looks like this {{ ::image-20191013-023557.png?200 | LabBot showing rails}}|MGN 12 rails you get from Amazon {{ ::image-20191013-193600.png?200 | What rails looks like on Amazon}}|


{{::iverntech_slider_shuttle_bottom.stl | Slider shuttle bottom}}
{{ ::iverntech_slider_tslot_connector.stl | Slider tslot connector}}
{{ :image-20191013-033914.png?200| Assembled slider 1}}
{{ :image-20191013-034324.png?200| Assembled slider 2}}




{{ :bdev:endstop_y.stl |}}

labautobox

User Tools

Site Tools

Page Tools