| {{:bdev:fff_extruder.png?400|}} | {{:bdev:extruder_bltouch_version.png?400|}} |


| [[http://52.200.33.55/devstlwork/catch.php?jscad=extruder_set_a.jscad&project=labbotbuild|extruder_set_a.jscad]] | Project: labbotbuild |
{{:bdev:extruder_set_a.jscad.png?400|}}

\\

| [[http://52.200.33.55/devstlwork/catch.php?jscad=extruder_with_filamentsensor.jscad&project=labbotbuild|extruder_with_filamentsensor.jscad]]  | Project: labbotbuild |
{{:bdev:extruder_with_filamentsensor.jscad.png?400|}}FFF extruder
\\

| bltouch clamp | {{ :bdev:bltouch_clamp.stl |}} | {{:bdev:bltouch_clamp.png?200|}} | 
| filament detection module  SIENOC 1.75mm 3D Filament Detection Module Filament Run-Out Pause Detecting Monitor Sensor for 3D Printer Lerdge Board| {{:bdev:filamentsensor.png?200|}} | {{:bdev:filament_detection_module.png?200|}} |
| e3d_v6 |{{:bdev:e3d_v6.png?200|}} | {{:bdev:e3d_v6_amazon_full_kit.png?400|}}| 
| hot_end_clamp | {{ :bdev:hot_end_clamp.stl |}}| {{:bdev:hot_end_clamp.png?200|}}|
| hot_end_fan_duct | {{ :bdev:hot_end_fan_duct.stl |}}| {{:bdev:hot_end_fan_duct.png?200|}}|
| idler | {{ :bdev:idler.stl |}} | {{:bdev:idler.png?200|}} |
| sensor | {{:bdev:sensor.png?200|}} | {{:bdev:sensor_amazon.png?200|}} |
| sensor_mount | {{ :bdev:sensor_mount.stl |}} | {{:bdev:sensor_mount.png?200|}} |
| turbine_duct | {{ :bdev:turbine_duct.stl |}} | {{:bdev:turbine_duct.png?200|}} |
| turbine_mount | {{ :bdev:turbine_mount.stl |}} | {{:bdev:turbine_mount.png?200|}} |  
| extruder_attach_motormountthin | {{ :bdev:extruder_attach_motormountthin.stl |}} | {{:bdev:extruder_attach_motormountthin.png?200|}} |
| extruder_connector | {{ :bdev:extruder_connector.stl |}} | {{:bdev:extruder_connector.png?200|}} |
| Extruder | {{ :bdev:extruder_with_filamentsensor.stl |}} | {{:bdev:extruder.png?200|}} |