====== X drive systems ======

After setting up the Y rails now its time to set up X drive. The first step is to get attach an extrusion to the 2 Y sliders:

|HFS5-2020-552-TPW |{{ :bdev:image-20191013-152131.png?200 |X rail}}|

Don’t fasten the X slider extrusion too tightly yet, since now you need to assemble the X slider


|{{ :bdev:image-20191222-164625.png?200 |}}|{{ :bdev:image-20200516-011155.png?200 |}}|{{ :bdev:image-20200517-043813.png?200 |}}|

Also need 4 M5 - 25mm long screws per side and 1 tslot20 100mm

|{{ :bdev:image-20200510-175947.png?200 |}}|iverntech_slider_tslot \\ {{ :bdev:iverntech_slider_tslot_connector_1_.stl |}}|
|{{ :bdev:image-20191222-165449.png?200 |}}|iverntech_slider_xshuttle_connect \\ {{ :bdev:iverntech_slider_xshuttle_connect.stl |}}|
|{{ :bdev:image-20191222-170341.png?200 |}}|slider_front_assy_multichannel_iverntech \\ {{ :bdev:slider_front_assy_multichannel_iverntech.stl |}}|
|{{ :bdev:image-20191222-170547.png?200 |}}|shuttle_back \\ {{ :bdev:shuttle_back.stl |}}|
|{{ :bdev:image-20191222-171950.png?200 |}}|beltclamp \\ {{ :bdev:beltclamp.stl |}}|
|{{ :bdev:image-20200516-011300.png?200 |}}|motormount_centered \\ {{ :bdev:motormount_centered.stl |}}|
|{{:bdev:endstop_x.png?200|}}|endstop_x \\ {{:bdev:endstop_x.stl |}}|