X drive systems
After setting up the Y rails now its time to set up X drive. The first step is to get attach an extrusion to the 2 Y sliders:
| HFS5-2020-552-TPW |  |
Don’t fasten the X slider extrusion too tightly yet, since now you need to assemble the X slider
 |  |  |
Also need 4 M5 - 25mm long screws per side and 1 tslot20 100mm
 | iverntech_slider_tslot iverntech_slider_tslot_connector_1_.stl |
 | iverntech_slider_xshuttle_connect iverntech_slider_xshuttle_connect.stl |
 | slider_front_assy_multichannel_iverntech slider_front_assy_multichannel_iverntech.stl |
 | shuttle_back shuttle_back.stl |
 | beltclamp beltclamp.stl |
 | motormount_centered motormount_centered.stl |
 | endstop_x endstop_x.stl |