bdev:fff_extruder
This is an old revision of the document!
| extruder_set_a.jscad | Project: labbotbuild |
| extruder_with_filamentsensor.jscad | Project: labbotbuild |
FFF extruder
| e3d_v6 |  |  |
| hot_end_clamp | hot_end_clamp.stl |  |
| hot_end_fan_duct | hot_end_fan_duct.stl |  |
| idler | idler.stl |  |
| sensor |  |  |
| sensor_mount | sensor_mount.stl |  |
| turbine_duct | turbine_duct.stl |  |
| turbine_mount | turbine_mount.stl |  |
| extruder_attach_motormountthin | extruder_attach_motormountthin.stl |  |
| extruder_connector | extruder_connector.stl |  |
| Extruder | extruder_fix.stl |  |
bdev/fff_extruder.1629743630.txt.gz · Last modified: 2021/08/23 18:33 by richard
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
