bdev:x_and_z_drive_systems
This is an old revision of the document!
X and Z drive systems
After setting up the Y rails now its time to set up X drive. The first step is to get attach an extrusion to the 2 Y sliders:
| HFS5-2020-552-TPW |  |
Don’t fasten the X slider extrusion too tightly yet, since now you need to assemble the X slider
 |  |  |
Also need 4 M5 - 25mm long screws per side and 1 tslot20 100mm
 | iverntech_slider_tslot iverntech_slider_tslot_connector_1_.stl |
bdev/x_and_z_drive_systems.1601131848.txt.gz · Last modified: 2021/08/16 22:21 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
