After setting up the Y rails now its time to set up X drive. The first step is to get attach an extrusion to the 2 Y sliders:

HFS5-2020-552-TPW

Don’t fasten the X slider extrusion too tightly yet, since now you need to assemble the X slider

Also need 4 M5 - 25mm long screws per side and 1 tslot20 100mm

	iverntech_slider_tslot iverntech_slider_tslot_connector_1_.stl
	iverntech_slider_xshuttle_connect iverntech_slider_xshuttle_connect.stl
	slider_front_assy_multichannel_iverntech slider_front_assy_multichannel_iverntech.stl
	shuttle_back shuttle_back.stl
	beltclamp beltclamp.stl
	motormount_centered motormount_centered.stl